OPERATION
18
Fig. 31
5
4
1
3
2
AUXILIARY FENCE (Fig. 32)
Making the base:
• Start with a piece of 3/8 in. plywood at least 5-1/2 in. wide
or wider and 21 in. long or longer.
• Cut the piece to shape and size shown.
Making the side:
• Start with a piece of 3/4 in. hardwood at least 1-3/4 in.
wide or wider and 21 in. long or longer.
• Cut the piece to shape and size shown.
Putting it together:
• Fasten the pieces together with glue and woodscrews.
Make sure the screw heads do not stick
out from the bottom of the base, they must be flush or
recessed. The bottom must be flat and smooth enough
to rest on the saw table without rocking.
CAUTION
Fig. 32
3/8 in. thick plywood base
21 in
3/8 in. plywood
3/4 in. hardwood
The edge must be
parallel with the face
1-3/4 in
3/8 in
5-1/2 in
PUSH BLOCK
Use for ripping operation when the workpiece is too narrow to
use a push stick. Always use a push block for rip widths less
than 2 in.
MAKE A PUSH BLOCK (Fig. 33)
Making the base:
• Start with a 3/8 in. plywood at least 5-1/2 in. wide or wider
and 12 in. long or longer.
• Cut the piece to shape and size as shown.
Making the handle:
• Start with a 3/4 in. hardwood at least 5 in. wide or wider
and 7 in. long or longer.
• Cut the piece to shape and size as shown.
Making the bracket:
• Start with a 3/8 in. wood at least 3/8 in. wide or wider and
2-1/2 in. long or longer.
• Cut the piece to shape and size as shown.
Putting it together:
• Fasten the base and handle together with glue and
woodscrews.
Make sure the screw heads do not stick
out from the bottom of the base, they must be flush
or recessed.
CAUTION
• Fasten the base and bracket together with glue.
To avoid injury, do not use the screws to
fasten the base and bracket.
CAUTION
3/8 in. thick plywood base
2-1/2 in
12 in
5-1/2 in
3/8 in
2-1/2 in
3/8 in
3/8 in
7 in
5 in
2
1
CROSSCUTTING (Fig. 34)
Fig. 33
To prevent serious injury:
CAUTION
• Do not allow familiarity or frequent use of your table saw
to cause careless mistakes. Remember that even a careless
fraction of a second is enough to cause a severe injury.
• Keep both hands away from the blade and the path of the
blade.
• Never attempt to pull the workpiece backwards during a
cutting operation. This will cause kickback and serious
injury to the user can occur.
1. Remove the rip fence and place the miter gauge in the
miter gauge groove on the table.
2. Adjust the blade height so that it is 1/8 in. higher than
the top of the workpiece.
Содержание KN BTS-10N
Страница 1: ...KN BTS 10N Table saw with stand Sierra de mesa para madera con base10 254 mm...
Страница 26: ...EXPLODED VIEW 25 KN BTS 10N Table saw with stand Sierra de mesa para madera con base10 254 mm...
Страница 55: ...KN BTS 10N Table saw with stand Sierra de mesa para madera con base10 254 mm VISTA DETALLADA 54...
Страница 58: ...www knova com mx...