KNOVA KN 7060 Скачать руководство пользователя

Страница: 4 / 16

uSE OF ExTENSION COrDS

USE ONLY THREE-WIRED EXTENSION CORDS that have 3-pronged plugs and 3-holed outlets that accept the tool’s plug. Repair

or replace damaged or worn cords immediately.
Be sure your extension cord is properly wired and in good condition. Do not use damaged extension cords. Always replace a dam-

aged extension cord.
When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord

will cause a drop in line voltage, resulting in loss of power and overheating. The table below shows the correct size to use accord-

ing to the cord length and the amperage draw of the tool (specified on the nameplate). When in doubt, use the next heavier gauge.

The smaller the gauge number, the heavier the cord. (AWG = American Wire Gauge).

Minimum Gauge for Extension Cords (AWG) (when using 120 volts only)

BEFOrE yOu STArT – PACKAGE CONTENTS

Left work rest ....................................................................... 1
Right work rest ..................................................................... 1
Plain eye shield .................................................................... 1
Magnifying eye shield ........................................................... 1
Eye shield fixing knob ........................................................... 2
Eye shield mounting rod – one left, one right
Eye shield assembly mounting bolt M6x30 ........................... 2

Ampere Rating

Total Length of Cord in Feet (meters)

More Than

Not more Than

25’ (7.6m)

50’ (15m)

100’ (30.4m)

150’ (45.7m)

12 Not Recommended

Use a separate electrical circuit for your tools. This circuit should not be less than a #12 gauge wire, and should be protected with a

15 A time-lag fuse. Before connecting the motor to the power line, ensure the switch is in the OFF position and the electric current

is rated the same as the current stamped on the motor’s nameplate. Running at a lower voltage will damage the motor and is not

covered by warranty.

Eye shield assembly mounting washer D6 ........................... 2
Eye shield assembly mounting locking washer D6 ............... 2
Fix work rest ...................................................................... 2
Adjustable work rest ........................................................... 2
Coolant tray ........................................................................ 1
Spark deflector ................................................................... 2
Spark deflector fixing screw assembly ................................ 2

BEFOrE yOu STArT – ASSEmBLy AND INSTALLATION

Mounting the Grinder to the Workbench
Before attempting to use this grinder, it must be properly mount-

ed to a workbench or grinding stand.
CAUTION! Bench grinders vibrate. Grinder movement during

high-speed rotation may cause injury or damage to the work-

piece or operator. Mount the grinder securely to a sturdy work-

bench or grinding stand.
1. Position the grinder on the workbench.
2. Mark the workbench through the two mounting holes located

in the grinder base.
3. Drill holes in the

workbench at the

marks.
4. Using two long

bolts, washers,

lock-washers and

nuts, as shown

(not supplied), secure

the grinder to

the workbench.

Workbench

Bolt

flat

washer

Flat washer

Hex nut

Eye Shield Installation
Eye shields must be installed before operating the bench grinder.
1. Mount the left and right shield rods to the inside of the wheel

guards using hex bolts.

2. Once shield rods

are firmly in place,

slide the shield bracket

onto the shield rod.

3. Tighten the carriage bolt,

leaving it loose enough to

allow the safety shield to be

raised and lowered easily.

Safety eye

shield

Eye shield