KNF N 0150, Инструкция по эксплуатации и установке

Страница: 48 / 80

5
1.3 List of safety and installation notes
Caution
Electric motors have dangerous, live and rotating parts. All work during connection,
commissioning, maintenance and disposal may only be carried out by qualified
professionals. (Observe EN50110-1 and IEC 60364) Before beginning any work, any
in particular before opening covers, the drive must be isolated according to
regulations. In addition to the main circuit, any auxiliary circuits which may be present
must be taken into account here.
Compliance with the 5 safety rules:
•
Isolate
•
Secure against being switched on again
•
Establish the absence of voltage
•
Earth and short-circuit
•
Cover or block off adjacent live parts
The measures specified above may only be withdrawn after the work has been completed and the
drive is fully installed. Improper conduct may result in injuries and property damage. The applicable
national, local and system-specific provisions and requirements must be observed and complied with.
Warning
The proper and safe operation of the products assumes proper transportation, proper
storage, positioning and installation, and careful operation and maintenance.
Caution
The surfaces of the motors may be ≥ 55 °C during operation! The hot surfaces should
not be touched.
Note
Products with a weight of ≥ 20 kg should only be moved and lifted with appropriate
lifting devices.
1.4 Limitation of liability
All information and instructions in this manual have been put together taking the applicable standards
and regulations, the state of the art and our many years of knowledge and experience into account.
The manufacturer assumes no liability for damage resulting from:
•
Failure to observe the manual
•
Improper use
•
Use of untrained personnel
•
Unauthorised modifications
•
Technical modifications
•
Use of unapproved spare parts