KNF N 012 AT. 16 E, Руководство по эксплуатации и установке

Страница: 9 / 24

Diaphragm Vacuum Pumps N 012, N 024, N 036 Operation
Translation of original Operating and Installation Instructions, english, KNF 121222-121485 08/11 9
WARNING
Hazard of the pump head bursting due to excessive
pressure increase
 Do not exceed max. permissible operating
pressure (see chapter 9).
 Monitor pressure during operation.
 If the pressure exceeds the maximum permissi-
ble operating pressure, immediately switch off
pump and eliminate fault (see chapter 7).
 Only throttle or regulate the air or gas quantity in
the suction line to prevent the maximum permis-
sible operating pressure from being exceeded.
 If the air or gas quantity in the pressure line is
throttled or regulated, make sure that the maxi-
mum permissible operating pressure is not ex-
ceeded.
 Ensure that the pump outlet is not closed or
constricted.
When the pump is at a standstill the inlet and exhaust must be at
normal atmospheric pressure.
When the operation of the pump is interrupted by the thermal
switch, the pump will re-start automatically after cooling down.
Take all care necessary to prevent this leading to a dangerous
situation.
Diaphragm and valve plates are the only parts subject to wear.
Wear is usually indicated by a drastic reduction in the pneumatic
performance. When replacing parts proceed as described in sec-
tion 5.
Ambient conditions: see section 1.3.
Operating pumps with electronic temperature control (.26
designs)