Setup Instructions:
Step 1: Install Front Axle
Please take your time to carefully complete all steps before operating
your KneeRover
®
scooter. Once the packing material is removed, install
the front axle using the 2 bolts and allen wrench provided. Place the front
axle under the frame, align the holes, insert the bolts, and tighten using
the allen wrench as shown in left photo. The photo in the middle is how
the axle should look when fully installed. The tie rods should be
assembled as shown in the right photo with one tie rod on top of the
black guide, and one below, with the nut tightened firmly at the bottom.
Step 2: Install Steering Column
The steering column will be in a folded position when unpacking. When
facing the front of the KneeRover
®
scooter, raise the steering column and
push the security pin in the clamp to the left (as shown in left photo) to
allow the column to lock into place. Raise the clamp lever upward and
tighten by turning it clockwise. Finally, push clamp lever down firmly to
secure the steering column (as shown in center photo). Reverse these
steps when needing to lower steering column for transport. Once knee
platform is installed, use the black knob (shown in right photo) to set the
handlebars at a comfortable height for operation.
Step 3: Install Knee Platform
The knee platform is designed to be used with either the right or left leg.
Remove the knee platform from the bottom of the KneeRover
®
scooter
by removing the locking pin and loosening the clamp. Next insert the
knee platform post into the receptacle tube and set the knee platform at
your desired height for use by inserting the locking pin through the
aligned holes. Finally, tighten the clamp to secure the knee platform in
place.
Step 4: Attach Basket & Inflate Tires
Removable basket attaches to the steering column. The pneumatic tires
come partially inflated. It is important to inflate all three tires to the
correct pressure (between 22 and 28 psi) the same way you inflate a
bike tire. Be careful not to over inflate the tires.
Locking Pin
Clamp
