ROLL-OUT WIRE HAMPER
Installation Instructions
KNAPE & VOGT MANUFACTURING COMPANY
P.O. Box 191, Muncie, IN 47308
0.899.6535 • 765.288.8730 • Fax 765.288.0851 • www.kv.com
RN-229EFS 04/03
Hamper Rollout
Inspect all parts and read all instructions prior to beginning assembly and installation.
Parts Included
A. Hamper basket assembly
B. Sliding base assembly
C. Mounting Screws
Tools Required
• Phillips head Screwdriver
• Drill with 1/16” (1.5mm) bit for
drilling pilot holes
• Pencil
Product Assemblies
H1215
H1218
H1515
H1518
Step 1
Place sliding base assembly on cabinet
floor, right behind the back edge of the
cabinet face frame. If installing in a
frameless cabinet, measure 1/2" to 3/4"
back from front of cabinet opening, and
align sliding base assembly parallel to
cabinet opening. Close door to make sure
the assembly will not hold cabinet door
open. Also, check to see if unit will clear
the door opening when fully extended.
Once position is determined, fasten in
place using four mounting screws provided
and the Phillips head screwdriver.
Optional step:
Mark placement of mounting holes with a
pencil, remove sliding base assembly and
drill pilot holes for fastening screws. Place
sliding base assembly back into position
and fasten with the provided screws.
Step 2
Slide hamper basket assembly
into sliding base assembly by
inserting wheels on basket into
tracks on sliding base assembly.
The basket should move freely
along the track. Assembly and
installation are now complete.
A
step 1
step 2
C
B
