KMS UEGO Display manual
Version 1.01
10
Extra channels
In this sub-menu you can change
the channel value in the left
(channel 1) en right (channel 2)
corner of your main screen
display.
At channel 1 you can
toggle for the left corner
‘air’ or ‘water’ in °C or
°F. Or just turn it off.
This is data that comes
straight from the KMS
management ECU.
Afterwards press save and
exit.
At channel 2 you can
toggle for the right corner
‘oil’ or ‘boost’ in kPa or
psi. Or just turn it off. This
is data from the KMS
management ECU.
Afterwards press save and
exit.
Output signal
This menu is very important for
the data transfer between
lambda controller and KMS
management ECU. You have to
set this output type the same in
your KMS management ECU
because of the same process of
information.
(note : in the appendix you can find a graph with the resolution of the different
types of data transfer (type a, b or c).
The different data types stand for the kind of signal they give out.
Type C has an output of 0-10 Volt(wideband for more resolution in your signal).
Most systems can’t handle more then 5 Volt so check if your system can handle this
high voltage before you set the lambda controller to type C.
Check the KMS management manual for additional information
)
Содержание UEGO
Страница 1: ...KMS UEGO Display manual Version 1 01 1 ...
Страница 14: ...KMS UEGO Display manual Version 1 01 14 ...
Страница 15: ...KMS UEGO Display manual Version 1 01 15 ...