KMS MD35, Руководство пользователя

Страница: 41 / 75

KMS MD35 manual
Version 4.16 41
3.2.4.1.9.4 Boost options
Clicking the „Boost options‟ tab gives you a pop-up screen
where the overboost and boost-reduction settings can be
setup.
3.2.4.1.9.4.1 Overboost settings
This system allows overboost for a limited time span. The
raise above the normal boost pressure can be activated
by various variables (refer to „activation input‟).
Activation input:
In the pulldown menu you can select which variable will trigger overboost. Behind the variable the
value can be set from which the overboost is allowed.
Overboost value:
When overboost is triggered, the boost pressure will rise above the target value by the percentage
entered here.
Overboost PWM map:
If overboost is active, the system will use the overboost
PWM map.
The values in the boost PWM map can be easily copied to
the overboost PWM map by selecting the cells and choose
„copy boost to overboost map‟. So the values in the
overboost PWM map can easily be increased by a
percentage over the boost PWM map values.
3.2.4.1.9.4.2 Enable window for activation
Here you can set the margins within which overboost is permitted.
Engine temp. + Air temp. On/off at>:
The overboost starts/stops when the engine temperature and air temperature are higher/lower
then the specified values.
Overboost activation time:
Specifies the time span during which overboost functions are active after being triggered.
Overboost pause time:
To prevent the overboost from being activated too rapidly (after a preceding overboost), you can
set a pause interval here before overboost can be triggered again.