4IN. x 36IN. BELT/6IN. DISC SANDER
OWNER’S MANUAL
3 of 7
USE TABLE WITH THE BELT
• Thread the Stud into the Belt Housing.
• Position the Table over the Stud and Bracket. Secure the
Table using the two Knobs.
• Thread the Locking Handle through the Table and in to the
Bracket
• Using a combination square, set the table perpendicular to
the belt and secure in position. If necessary, set the Pointer
to 0º .
GROUNDING INSTRUCTIONS
WARNING: Improper connection of equipment ground-
ing conductor can result in the risk of electrical shock.
Equipment should be grounded while in use to protect
operator from electrical shock.
• Check with a qualified electrician if grounding instructions
are not understood or if in doubt as to whether the tool is
properly grounded.
• This tool is equipped with an approved 3-conductor cord
rated at 150V and a 3-prong grounding type plug (Figure 7)
for your protection against shock hazards.
• Grounding plug should be plugged directly into a properly
installed and grounded 3- prong grounding-type receptacle
as shown.
Do not remove or alter grounding prong in any manner. In the
event of a malfunction or breakdown, grounding provides a
path of least resistance for electrical shock.
WARNING: Do not permit fingers to touch the terminals
of plug when installing or removing from outlet.
• Plug must be plugged into matching outlet that is properly
installed and grounded in accordance with all local codes
and ordinances. Do not modify plug provided. If it will not fit
in outlet, have proper outlet installed by a qualified electri-
cian.
• Inspect tool cords periodically, and if damaged, have
repaired by an authorized service facility.
• Where a 2-prong wall receptacle is encountered, it must be
replaced with a properly grounded 3-prong receptacle
installed in accordance with National Electric Code and local
codes and ordinances.
WARNING: This work should be performed by a quali-
fied electrician.
A temporary 3-prong to 2-prong grounding adapter (as shown)
is available for connecting plugs to a two pole outlet if it is
properly grounded.
• Do not use a 3-prong to 2-prong grounding adapter unless
permitted by local and national codes and ordinances. (A
3-prong to 2-prong grounding adapter is not permitted in
Canada.)
Where permitted, the rigid green tab or terminal on the side
of the adapter must be securely connected to a permanent
electrical ground such as a properly grounded water pipe, a
properly grounded outlet box or a properly grounded wire system.
• Many cover plate screws, water pipes and outlet boxes are
not properly grounded. To ensure proper ground, grounding
means must be tested by a qualified electrician.
GUIDELINES FOR EXTENSION CORDS
•
Use a proper extension cord.
Make sure the extension cord
is in good condition. When using an extension cord, be sure
to use one heavy enough to carry the current your product
will draw. An undersized cord will cause a drop in line
voltage, resulting in loss of power and possible overheating.
•
Be sure the extension cord is properly wired and in good
condition.
Always replace a damaged extension cord or have
it repaired by a qualified person before using it. Protect your
extension cords from sharp objects, excessive heat and
damp or wet areas.
OPERATING INSTRUCTIONS
CONTROLS AND ADJUSTMENTS
SANDING SAFETY TIPS
WARNING:
Operation of any power tool can result in
foreign objects being thrown into the eyes, which can
result in severe eye damage. Always wear safety goggles
complying with United States ANSI Z87.1 (shown on package)
before commencing power tool operation.
CAUTION:
Always observe following safety precautions.
Horizontal to Vertical
Pivot Socket Bolt
Belt Tracking
Adjusting Knob (35)
Belt Tension Lever
Table Angle Scale
Switch
