KLUBB K38P, Руководство пользователя

Страница: 33 / 64

33
BEFORE USING THE OUTRIGGERS always check the area where they will be set (chose a firm
and stable ground, avoid manholes, make sure not to crush anybody’s feet), use spreader plates.
•
Actuate the elevator boom lifting control (it must always be the first maneuver carried
out with the elevator) to remove the boom from the base (at low speed and to a minimum
elevation of 0.5m).
Once all these steps have been taken, you can carry out the movements needed for the work to
be done while keeping at a safe distance from electricity lines and any obstacles around you.
•
Before lowering the main boom onto its support, you must check that:
- The telescopic boom is fully retracted.
- The pendular boom is retracted as far as possible.
- The platform is exactly horizontal.
- The boom is in line with the vehicle.
•
For a carrier chassis: Use the two triangular marks, one on the column and the other on
the turret, for alignment. These two marks must be properly aligned.
•
Once these points have been checked, you can lower the main boom until it abuts. (If the
two triangles are properly aligned, there is no need to look at the receptacle at the bottom
of the platform).
USING THE ELEVATOR FROM THE GROUND:
•
The necessary procedure is the same as the one used for use from the upper control panel
except that instead of selecting the upper control panel you must select the bottom remote
control panel using the key switch on the main electric box.
•
the bottom remote control panel is mounted to the column.
www. duma -rent.com