klover DEA ECO 6, Руководство пользователя

Страница: 94 / 139

25
EN
G
L
ISH
INITIAL START-UP
Pellet loading and connection to the electricity network
Perform the following operations:
− Connect the stove to the electrical system using the cable supplied;
− Position the switch on the rear side of the stove on “
׀
” (on);
− Fill the pellet tank; for the initial start-up use that specified in “
MENU 06
– FIRST LOADING”
in order
save the time required for filling up the screw feed channel completely (this operation must be
performed every time the stove is without pellets);
− Switch the stove on using the relevant ignition button on the Control Panel. See the instructions below.
We recommend using high-quality pellets so as avoid jeopardising the stove's functionality. Damages
caused by poor-quality pellets shall not be covered by the warranty.
Stove ignition cycle
Pressing button 3 (ON/OFF) for a few seconds allows to start the stove ignition cycle. After a few seconds,
“START”
will appear on the display, while the flue gas extractor and the ignition heating element will switch
on. After 8 seconds, the stove will enter the
“PELLET LOADING”
pre-loading phase for quickly filling the
brazier with pellets. After the pre-loading phase, the stove enters the stand-by mode without loading any fuel,
before restoring the
“PELLET LOADING”
phase in which an intermittent loading operation is performed while
the pellets in the brazier begin to ignite. When the flame is on and the proper temperature has been reached,
the display will visualise
“FIRE PRESENT”
. This phase let's the fire expand evenly throughout the brazier.
After these phases, the stove enters the work mode at the pre-set power value.
If the pellets do not ignite, the stove enters the
“NO IGNITION”
alarm mode.
The alarm may also occur if the brazier is dirty; in this case, clean the brazier and re-start the stove.
Summary:
The ignition cycle may last maximum 25 minutes and is divided into three phases:
1 - START : Flue gas extractor starts
Heating element starts
duration = 8 seconds
2 - PELLET LOADING : Pellet pre-loading phase (initial continuous loading) followed by
intermittent pellet loading phase.
Max. duration = Pr01
3 - FIRE PRESENT : Heating element switches off
Flame stabilisation.
Pr02 = start time
After the ignition cycle, the stove enters the work phase at the previously set power value.