KlipXtreme KPM-400W, Руководство по установке

Страница: 3 / 24

• The use of this product with elements heavier than the rated weights indicated may result in
instability causing possible injury.
• Proper installation procedure by a qualified service technician must be followed, as outlined in
these installation instructions. Failure to do so could result in property damage, serious personal
injury, or even death.
• Safety measures must be practiced at all times during the assembly of this product. Use proper
safety equipment and tools for the assembly procedure to prevent personal injury.
• KlipXtreme does not warrant against damage caused by the use of any KlipXtreme mounts for
purposes other than those for which it was designed or damage caused by unauthorized
attachments or modifications, and is not responsible for any damages, claims, demands, suits,
actions or causes of action of whatever kind resulting from, arising out of or in any manner
relating to any such use, attachments or modifications.
• At least two qualified people should perform the assembly procedure. Personal injury and/or
property damage can result from dropping or mishandling the projector.
• If mounting to wall studs or ceiling studs, make sure that the mounting screws are anchored into
the center of the wall studs or ceiling studs. Use of an edge-to-edge stud finder is recommended.
DO NOT OVER TIGHTEN mounting screws.
• Be aware of the mounting environment. If drilling and/or cutting into the mounting surface,
always make sure that there are no electrical wires in wall. Cutting or drilling into an electrical line
may cause serious personal injury.
• Make sure there are no water or natural gas lines inside the wall where the mount is to be
located. Cutting or drilling into a water or gas line may cause severe property damage or
personal injury.
• This product contains small items that could be a choking hazard if swallowed. Keep these items
away from children.
• This product is intended for indoor use only. Use of this product outdoors could lead to product
failure and/or serious personal injury.
• Do not install near sources of high heat. Do not install on a structure that is prone to vibration,
movement or chance of impact.
Installation tools
The following tools may be required depending upon your particular installation. These tools are
not included with the product.
1) Protective eyewear
2) Stud finder
3) Hand-held/cordless drill
A) Ceiling plate (1)
B) Projector plate (1)
C) M3x8 (M-A) bolt (4)
D) M4x10 (M-B) bolt (4)
E) M5x10 (M-C) bolt (4)
F) M6x10 (M-D) bolt (4)
G) D3 (M-E) washer (4)
H) D4 (M-F) washer (4)
I) D5 ø5xø12 (M-G) washer (4)
J) D6 (M-H) washer (4)
K) M5x12 (M-I) head bolt (2)
L) D5 ø5xø10 (M-J) washer (2)
M) D5 (M-K) washer (2)
N) Allen wrench (M-L) (1)
O) W-A wood/concrete screw (4)
P) W-B concrete anchor (4)
Q) W-C washer (4)
Package contents
Make sure none of these parts are missing or damaged before beginning installation.
Hardware
A(x1) B(x1)
M-L (x1)
W-A (x4) W-B (x4) W-C (x4)
D3 (x4)
M-E
D5 Ø5xØ12 (x4)
M-G
M4x10 (x4)
M-B
M5x10 (x4)
M-C
M6x10 (x4)
M-D
D4 (x4)
M-F
M3x8 (x4)
M-A
D6 (x4)
M-H
M5x12 (x2)
M-I
D5 (x2)
M-K
D5 Ø5xØ10 (x2)
M-J
4) Pencil
5) 3/16” drill bit (wood)
6) Hammer
7) 3/8” masonry drill bit
8) Phillips screwdriver
9) Ladder
1 3 4 5
9 8 7 6
2