Label
G
H
I
J
K
L
M
M-A
M-B
M-C
M-D
M-E
M-F
N
O
P
Q
Quantity
1
1
1
1
1
4
2
4
4
4
4
4
4
5
3
1
1
Image
Item
Shaft
Cap
Cable clip with tool holder
Grommet base
Flat clamping plate
M4x8 screw
M6x10 screw
M4x12 screw
M4x16 screw
M5x12 screw
M5x16 screw
D5 metal flat washer
M-F plastic washer
Silicone pad ø15x1.5
M6x16 shaft mounting screws
4mm allen wrench
6mm allen wrench
IMPORTANT:
At least two qualified people should perform the assembly procedure. Personal injury and/or
property damage can result from dropping or mishandling the display.
Mounting surfaces must be sturdy and flat.
Do not install this product on a weak, uneven surface, prone to vibration or susceptible to
other movements. Reinforce the structure as necessary before installing the mount.
Maximum weight supported:
Supported monitor weight: up to 17.65lbs
Supported laptop weight: up to 9.9lbs
The combined weight of all components shall not exceed the rated load capacity of the
mounting arm.
2. WARNING!
• Prior to installing this product, you must read all instructions thoroughly. Keep these
installation instructions in an easily accessible location for future reference.
• Safety measures must be practiced at all times during the assembly of this product. Use
proper safety equipment and tools for the assembly procedure to prevent personal injury.
• Klip Xtreme does not warrant against damage caused by the use of any Klip Xtreme mounts
for purposes other than those for which it was designed or damage caused by unauthorized
attachments or modifications, and is not responsible for any damages, claims, demands, suits,
actions or causes of action of whatever kind resulting from, arising out of or in any manner
relating to any such use, attachments or modifications.
3. Assembling instructions
1. Insert the cap (H) into the shaft (G).
2a. Using the C-clamp to Mount
- Attach the five silicone pads ø15x1.5 (N) to the top of the C-clamp (F).
- Then, use the 4mm allen wrench (P) and the M6x16 screws (O) to secure the shaft onto the
C-clamp.
- Once this step is complete, slide the clamp base onto the edge of your desktop in the
desired location. Tighten the locking knob by turning the knob counter clockwise until the
knob is securely attached to the desk surface, but be careful not to overtighten it as you
could damage the desk surface.
H
G
