3. Insert the two mounting arms into the shaft placing the cable clip with tool holder between
them. Place one mounting arm close to the bottom of the shaft and the other mounting arm
close to the top. Tight both mounting arms to the shaft using the 6mm allen wrench.
CAUTION:
Determine the correct screw size and mark the depth of the mounting point.
Please note that not all the hardware included will be used. Verify the adequate thread
engagement of the screw on your monitor.
4. Place the four D5 metal flat washers (M-E) in the corners of the VESA monitor plate. Insert
the four suitable screws (choose among the M-A, M-C and M-B, M-D sizes) on top of the
D5 metal flat washers into the VESA monitor plate and the mounting holes on the back of
the monitor.
I
B
Q
I
10-88mm
P
O
F
N
2b. Using the grommet as your base:
- Remove the locking knob and the plate from the C-Clamp
- Attach the five silicone pads ø15x1.5 (N) to the top of the grommet base (J)
- Align the grommet base onto the pre-drilled hole on the desktop location where the mount
will be installed. (Note: a hole needs to be pre-drilled on the desktop to complete this
setup)
- Place the flat clamping plate (K) into the locking knob.
- Then, proceed to align the shaft (G) with the grommet, insert the locking knob in the
pre-drilled hole on the desktop and secure the shaft.
- Tighten the locking knob by turning the knob clockwise until the shaft is securely attached to
the desk surface, but be careful not to overtighten it as you could damage the desk surface.
F
J
K
10-88m
m
N
M-A
M-C
M-E
M-B
M-D
M-E
M-F
TV
TV
TV
A
