KlinMak HILO 8065, Инструкция по эксплуатации

Страница: 46 / 62

Instruction Manual IDO
8065
-HILO
8065
24/08/15 Rev: 1.0.0 (TRANSLATION OF ORIGINAL LANGUAGE)
46
8. Connect the battery charger to the battery connector. Connect the battery charger
cable to the power outlet. The charge indicator shows that the batteries are under charge.
9. When the batteries are completely charged, disconnect the battery charger from the
batteries.
10. Connect the batteries to the machine connector.
11. Check electrolyte level. The level must reach the gauge. If necessary, add distilled
water.
12. Lower the upper recovery tank into its position.
15.3. BRUSH PLATE ADJUSTMENT
RIDO
8065
The brush plate is pre-shaped for optimal adherence to the floor. By using the
control panel the brush plate is fully raised or completely lowered.
HILO
8065
The brush plate is pre-shaped for optimal adherence to the floor. There is the
option of adjusting the brush plate pressure on the ground, to have a more or less
effective scrubbing action. Use the panel button to do that.
The switch controls the pressure exerted on the floor by the brushes. To decrease
pressure, press the top of the switch. To increase the pressure, press the bottom part of
the switch and check the led display that indicates the pressure exerted by the brushes on
the floor.
15.4. BRUSH REPLACEMENT
This is done as follows.
1. With the brush plate lifted, turn the ignition key to OFF, the parking brake is engaged.
2. Press on the top of the brush, so to remove the it from its rim hub and let it drop on
the floor.