KlinMak HILO 8065, Инструкция по эксплуатации

Страница: 22 / 62

Instruction Manual IDO
8065
-HILO
8065
24/08/15 Rev: 1.0.0 (TRANSLATION OF ORIGINAL LANGUAGE)
22
9. REASONABLY FORESEEABLE INCORRECT USE OF THE
MACHINE
WARNING
The machine is not intended for outdoors use.
Do not wash and extract corrosive, flammable, explosive liquids, even if diluted.
It is strictly forbidden to use the machine in environments with explosion hazard where
there are flammable and explosive gases, vapours, liquids and powders.
FOR SAFETY
Do not wash the floors with water hotter than 50°C;
Do not use diesel fuel/benzene or corrosive detergents for washing floors;
WARNING
The machine has been designed for being used on flat surfaces and small slopes.
The maximum slope allowed, feasible uphill both during the operating and the transfer
phases, is equal to 7% (corresponding to a ramp with an inclination of about 4°).
To cover the same ramp downhill, you need to shift into reverse, as indicated in the
following pictures, where the proper use is shown (downhill shifted into reverse) and the
misuse (downhill covered in the normal direction of travel).
The above-mentioned incorrect behaviour, because of possible surface condition (wet,
bumpy or made of low-friction material), can lead to dangerous slipping or prolonged
stopping distances, even more evident and risky in the transfer phase when the machine
is moving and the disk brush is raised from the floor.