KlinMak HILO 8065, Инструкция по эксплуатации

Страница: 37 / 62

Instruction Manual IDO
8065
-HILO
8065
24/08/15 Rev: 1.0.0 (TRANSLATION OF ORIGINAL LANGUAGE)
37
The indicator beside the switch indicates the pressure value of the brushes. Once the
brushes plate is lowered on the floor, at the end stroke and while operating, this
indicator will signal with a red colour (more pressure) to green (less pressure) the force
exerted on the floor by the brushes (and the corresponding electric motor absorption).
It is recommended, depending on the state of dirt of the floor or on the floor type, to lift
the brush plate until the machine is operated with green light on, so to have a longer
battery service life. In case of very dirty floor, where it is necessary to have a high brush
pressure, the machine should be operated with the indicator turned red.
The flashing red indicator means the maximum pressure allowed for brushes has been
reached.
The load that can be exerted on the floor by brushes is adjustable from a minimum of 0
kg, up to a maximum of 41 kg (instead fixed in RIDO).
14.3.6. TRAVEL DIRECTION SELECTOR (6)
The selector lets you choose the travel direction. Setting it to FW (FORWARD), the
machine moves FORWARD when the speed pedal is pressed. Setting it to BW
(BACKWARD), motion will be in reverse as soon as the pedal is pressed.
14.3.7. WATER-DETERGENT SOLUTION FLOW CONTROL
KNOB (7)
The knob controls the flow in litres/minute of the solution to the brush plate.
To increase the flow, turn the solution control knob clockwise.
To decrease flow, turn anticlockwise.
Adjustment ranges from 0 litres/minute to 3.5 litres/minute.
If the brush motor is de-activated or if the speed control pedal is in the idle position the
solution flow is automatically interrupted until the brush motor and machine motion are
resumed. This function prevents unintentional discharging of the solution tank and
allows the operator to adjust the solution flow without needing to adjust it again each
time.
14.3.8. CHEMICAL METERING CONTROL KNOB, only for Ki-
Do supplied version (8)
The knob controls the flow of the chemical detergent which is going to be mixed with
the water poured in the clean water tank to form the detergent solution.
To increase the chemical detergent percentage in the aqueous solution, turn the control
knob clockwise.
To decrease the flow, turn anticlockwise.
The solution percentage that may be created ranges from 0% (no chemical detergent
added to the duct that feeds directly the brushes) to 3% of detergent volume, with
respect to the volume of water conveyed to the brushes).