The AIR DIRECTION and SWING buttons will be disabled when the air conditioner is not in
operation (including when the TIMER ON is set).
Do not operate the air conditioner for long periods with the air flow direction set downward
in cooling or dry mode. Otherwise, condensation may occur on the surface of the horizontal
louver causing moisture to drop on to the floor or on furnishings.
Do not move the horizontal louver manually. Always use the AIR DIRECTION or SWING
button. If you move this louver manually, it may malfunction during operation. If the louver
malfunctions, stop the airconditioner once and restart it.
When the air conditioner is started immediately after it was stopped, the horizontal louver
might not move for approximately 10 seconds.
Open angle of the horizontal louver should not be set too small, as COOLING or HEATING
performance may be impaired due to too restricted air flow area.
Do not operate unit with horizontal louver in closed position.
When the air conditioner is connected to power (initial power), the horizontal louver may
generate a sound for 10 seconds, this is a normal operation.
CAUTION
!
6
AUTOMATIC OPERATION
When you set the air conditioner in AUTO mode, it will
automatically select cooling, heating(cooling/heating
models only), or fan only operation depending on what
temperature you have selected and the room temperature.
The air conditioner will control room temperature
automatically round the temperature point set by you.
If the AUTO mode is uncomfortable, you can select
desired conditions manually.
ECONOMIC OPERATION
When you push ECONO button during cooling, heating
(cooling only type without),or AUTO operation , the air
conditioner will start following operation . The fan speed
will be automatically controlled .In the operation
suppression zone where capacity is kept to the minimum ,
overcooling is prevented by raising the temperature
setting by 1
after 1 hour and by 2
after 2 hours of
operation. The room temperature is thus regulated
between the operation suppression zone and the set
temperature.(It depends on the outdoor temperature.)
DRYING OPERATION
The dry mode will automatically select the drying
operation based on the difference between the set
temperature and the actual room temperature.
The temperature is regulated while dehumidifying by
repeating turning on and off of the cooling operation or
fan only. The fan speed indicator will display AUTO and
low speed will be used.
Cooling
Cooling
Time
DRYING operation
Room
temperature
set temperature
Cooling
Fan only
Fan only
HOW THE AIR CONDITIONER WORKS
operation suppression zone
2 hours
Set temperature
1 hours
ECONOMIC Operation
o
p
e
ra
ti
o
n
s
ta
rt
s
1
2
