4
13.
“
SWING
”
Press this button to enable the horizontal vanes to swing
automatically. To stop the vanes from moving and position
them in a particular direction, press the button again once
they reach the desired point.
14.
“
HEALTH
”
Press this button, to turn the health function on and off.
15.
“
FUNGUSPROOF
”
button
This A/C has special dry and anti-mold functions which
have “yes“ or “no” selections. This function is controlled by
the remote control in the cooling, dry and auto (cooling and
dry) modes. The purpose of this function is to dry the inside
of the evaporator and to prevent mold growth and odor.
Note:
Note:
This function has not been set in the factory. You may
freely set and cancel this function. The setting method
is as follows:
Make sure both the A/C and remote control are in the OFF
status. Point the remote control toward the A/C and
continuously press and hold the FUNGUSPROOF button.
Allow the unit to beep 5 times, then release the button.
The function will be set. Once you have set this function,
it will be programmed as default. Unless the entire
system is turned off or is restarted due to a power
outage, in order to remove it from the default, you will
have to manually cancel it.
CANCELLING FUNGUSPROOF
First, turn off the entire A/C system. Next, point the
remote control toward the A/C press and hold the
“FUNGUSPROOF”until it beeps 5 times, then release the
button.
If FUNGUSPROOF is running, it is suggested to let the
cycle complete before restarting the A/C.
This function will not run if the timer has been stopped
or the system has been stopped due to the sleep mode.
