www.klever-mobility.com
www.klever-mobility.com
38
39
5.5.4 Transport of the battery pack
E-bike battery packs are subjected to the IATA Dangerous
Goods Regulations, which are dealing with the safe
transportation of dangerous goods in commerce. As the
owner of a Klever E-bike you can transport the battery
pack by road and train without limitations and any
further requirements. However, when being transported
by third parties (e.g., forwarders, post or via air) special
requirements on packing and labelling of the battery pack
must be observed. In that case, please consult an expert
for the transport of hazardous materials.
Ship the battery only when the casing is undamaged.
Tape or mask off open contacts and pack up the battery in
such a manner that it cannot move around in the packing.
And please also observe detailed national regulations.
Please note! In every case of transporting a broken or
damaged battery, always refer to an authorised Klever
dealer. The dealer can inspect the battery and, in case
necessary, forward the broken battery to Klever Mobility.
5.6 Elementary diagnostics and
troubleshooting of the electric system
The system will not turn on
Check all connections. Check whether the battery is sitting
correctly in the docking station in the frame and whether the
battery lock is engaged.
The system can be turned on, but does not give any
electric motor support
Check all connections from and to the rear wheel motor.
Please note! In case it is not possible to solve the
above problems, contact your local Klever dealer or our
technical hotline.
Image 5.29
Image 5.30
Image 5.31
Klever’s E-bike drive train
Klever’s E-bike drive train
5.5.3 Removal and mounting of the
battery pack
The battery is automatically locked in place with the battery
lock and thereby protected from theft. To remove the battery,
first turn off the system using the On/Off button on the
display. Turn the key in the battery lock clockwise up to
the stop and pull out the battery with the handle from its
docking station (image 5.29). Now you can charge the battery
separately or store it safely for a longer break.
Having removed the battery pack from your E-bike, please
don’t forget to protect the contact connector of the controller
unit with the rubber cover. We advise to always use the
rubber cover when the battery is taken out of the docking
station (image 5.30).
Mounting the battery in the docking station
Insert the battery carefully. Make sure the groove of the
battery casing is carefully inserted into the rail of the bicycle
frame. Then slide the battery pack gently down until you hear
the lock engage and the electronic contacts are connected
(image 5.31). For this operation you do not need the key of the
lock. The lock will automatically snap in place and the battery
will be locked. The system is ready for operation and the
battery protected from being stolen.
Caution! Do NOT ride your E-bike without battery! Prior
to starting the system, make sure to check whether the
electronic contacts of the battery are engaged and locked
in place. Riding your E-bike without the battery could
possibly damage the Klever BIACTRON system.
