Klenn Air Horns JL-JK-OBA, Руководство по установке

Страница: 5 / 35

JL-JK-OBA
Installation and Operation Manual
Go to Table of Contents PG 5/35 REV: A (1/21/2019)
1. LIST OF FIGURES
Figure 1 - Suggested Ignition Relay Diagram for JL-JK-OBA; Air Horn Also Shown ................................................. 18
Figure 2 - Suggested Wire Routing for Air Compressor and Pressure Switch (JLU Shown) .................................... 19
Figure 3 - Compressor Mounted onto JK-101 **JK6450 Upgrade Shown .............................................................. 22
Figure 4 - Compressor Fasteners Orientation (Stack-Up)........................................................................................ 22
Figure 5 - Rubber Trim Attached to JK-201 (Bracket shown on bench) .................................................................. 23
Figure 6 - JK-202 Attached to JK-201 ....................................................................................................................... 23
Figure 7 - JK-202 Hand Formed/Bent around Air Tank ........................................................................................... 24
Figure 8 - JK-202 Air Tank Strap with Rubber Trim.................................................................................................. 24
Figure 9 - JK-201 to Evap Canister Install ................................................................................................................ 25
Figure 10 - JK-201 to JKU Mounting Points for Hardware ....................................................................................... 26
Figure 11 - JK-201 & JK-203 Mounting Strap Install over Crossmember ................................................................. 27
Figure 12
– JLU Rear Crossmember Mounting Locations ........................................................................................ 28
Figure 13 - JL-204 Adapter Bracket Bolted in Place ................................................................................................. 28
Figure 14
– JLU Middle Crossmember & Ground Strap Mounting Point ................................................................ 29
Figure 15 - JK-201 to JLU Mounting Points for Hardware ....................................................................................... 29
Figure 16 - JK-201 & JL-204 Hardware Attached ..................................................................................................... 30
Figure 17 - JK-201 & JL-204 Section View with Hardware Stack Up ........................................................................ 30
Figure 18
– Ground Strap Nut removed; JK-201 Tank Bracket shown in place ....................................................... 31
Figure 19 - JK-201 Mounting Points......................................................................................................................... 31
Figure 20 - Air Tank Mounted to JK-201 .................................................................................................................. 32
Figure 21 - JK-101 Mounted to Tank Bracket (Air Tank not shown) ....................................................................... 33
Figure 22 - Air Coupler Mounted To Bumper ......................................................................................................... 33