Klemsan GTOR-4, Руководство пользователя

Страница: 9 / 24

9
GPRS/SerialGateway
USB Port:
That port is where the Micro-USB cable is connected. This input can also be used as a
power connection.To use the “GatewayMaster” program; this port must be connected to
the computer. However, GPRS functions of GTOR will not work when GTOR is energized
via USB.
The GTOR scan for 5 seconds at startup to see if the Micro-USB cable is plugged in, and
the RX and TX LEDs will blink during this time. If the micro-USB cable is plugged in, the RX
and TX LEDs are always on and the GTOR is ready to be configured via “GtorUSBConfig”
via USB. If the Micro-USB cable is not plugged in, the RX and TX LEDs will go out and the
GTOR is prepare to perform its basic functions.
RS485 Port:
Provides, communication with serial devices that MODBUS RTU and Modbus ASCII
protocols supported.
Antenna:
The SMA type connection where the external antenna connection is made.
ON LED:
If the LED is on, the device’s supply is from the DC-, DC+ input. Or the micro-USB cable is
plugged into the device.
RSSI LEDs:
It indicates connected to the GSM network and shows the signal strengths.
-113dB <RSSI ≤ -101dB All LEDs are off.
-99dB <RSSI ≤ -93dB S1 LED is on. S2, S3 and S4 LEDs are off.
-91dB <RSSI ≤ -85dB The S1 and S2 LEDs are on. S3 and S4 LEDs are off.
-83dB <RSSI ≤ -77dB The S1, S2 and S3 LEDs are on. S4 LED is off.
-75dB <RSSI All LEDs are on.
The RSSI LEDs blink continuously if a Micro-SIM card is not inserted or a Micro-SIM card
with a PIN lock is inserted.
CONN LED:
When the LED is blinking the device is ready to operate in server mode. When the LED is
on continuously, it means the device is turned on in server mode and is connectable to
the device. When the LED flashes, it means that the RST button is pressed and the device
will return to the factory settings.
RX LED:
The GTOR will scan for 5 seconds at startup to see if the Micro-USB cable is plugged in,
and the RX LED flashes during this time. If the Micro-USB cable is plugged in, the RX LED
is always on. If the micro-USB cable is not plugged in, the RX LED goes out. It means that
when the LED is on, the data from the serial device comes to the GTOR while the GTOR is
performing its essential functions.
TX LED:
The GTOR will scan for 5 seconds at startup to see if the Micro-USB cable is plugged in,
and the TX LED flashes during this time. If the Micro-USB cable is plugged in, the TX LED
is always on. If the micro-USB cable is not plugged in, the TX LED goes out. It means that
when the LED is on, the data from the GTOR comes to the serial device while the GTOR
is performing its essential functions.
SECTION 2 INSTALLATION