9
Timer touch control
It is possible to scroll the oven functions menus by pressing the
symbols.
The current function will flash for a few seconds and the set temperature assigned
to the function will appear (certain functions do not envision the adjustment of the
temperature, in this case no value appears). The symbol
and flashing writing
PAUSE
, indicate the oven is ready for cooking in the chosen function but cooking
has not yet started.
Adjust of the temperature assigned to a function
To amend the temperatures defined automatically for each function, slightly press
symbol
and act on
+
and
–
adjusting the temperature with 5°C intervals. After a
few seconds the new value is set and stops flashing. Press
for cooking to start
again.
To go back to the pre-set temperature, repeat the procedure or exit and access the
function again.
Once definitively changed the temperature set by the manufacturer, press symbol
until a warning beep is emitted (about 5 seconds) and the temperature digits stop
flashing.
Manual functioning
Once the function is selected, act on
to start cooking; the display will show the
set temperature. The
PAUSE
symbol disappears and the timer starts indicating the
time past from cooking start. Cooking will continue until manually interrupted (see
entries “cooking pause/start/end”) or has reached the maximum limit pre-set by
the manufacturer. The maximum achievable cooking time limit varies depending on
the temperature set in the following values:
For temperatures:
from 50 – 120°C max time 10h; from 121 – 200°C max time
6h; from 201 – 250°C max time 3h.
In semi-automatic and automatic cooking, as described further below, cooking is
automatically interrupted as from previously set parameters.
Cooking pause, amendment or end functions
Pressing on
during cooking interrupts the same and the symbol
PAUSE
starts flashing. All oven elements are temporarily disabled. All display indications
disappear by touching
again. The display will indicate the eventual remaining
temperature (see entry “remaining temperature”). Pressing
once, the last
interrupted setting appears again, and pressing it a second time, starts cooking
again.
To amend the parameters (functions, temperatures, etc.) follow the above
indications, pressing
at the end to confirm.
Semi-automatic functioning (with cooking time duration set)
This function allows programming the wanted cooking end time with immediate
start of the same, setting the wanted cooking duration time. In this case it is not
possible to use the food probe.
To activate semi-automatic functioning, select the wanted oven function from the
menu and, eventually, adjust the cooking temperature as previously described.
Slightly touch symbol
, the digits
0:00
of the timer will start to flash. Adjust the
wanted cooking duration time (the symbol
AUTO
appears) and press
, cooking
starts immediately and the display will show the time it will end, as set by you.
An acoustic signal will warn of cooking end, press
to interrupt the acoustic
signal. It is possible, at any moment, to vary the time and temperature function
parameters set as previously described.
Press
to interrupt cooking, the writing
PAUSE
appears, press
a second
time to cancel the program.
Semi-automatic functioning (with cooking time end set)
In this case, it is possible to set the wanted cooking time end with immediate
start, without indicating its duration. As for previous function, in this case it is not
possible to use the food probe (where envisioned).
Control Panel Functions
= On/Off
= Start Programme
= Stop/Pause Programme
= Adjust Temperature
= Increase Number
= Decrease Number
= Scroll Down Values
= Scroll Up Values
= Activate Boost
(quick heating)
= Adjust Time
= Light On/Off
= Safety Lock On/Off
