KKT KOLBE BASE 604S/ED/WED, Инструкция по эксплуатации и монтажу

Страница: 33 / 40

33 33
Only connect the appliance to the power
supply once it is properly installed.
7.2 Using the extractor hood as
an exhaust air hood (with air
extracted to outdoors)
If the extractor hood has been fitted at
the factory with a carbon filter, this must
be removed. It is only practicable to use
this when operating your hood in circu -
lation mode.
7.3 Converting the extractor
hood to a circulation hood
If you wish to use an appropriately fitted
hood as a circulation hood, you must
mount the active carbon filter(s) to the
fan motor before using the hood. The ac -
tive carbon filter(s) is/are included in the
scope of supply with some models.
Otherwise you must obtain the active
carbon filter(s) from the supplier of your
extractor hood. You must also change
your hood over to the „Filter position“ at
the device provided (lever or ball hand -
le).
7.4 Electrical connection
Before connecting the extractor hood,
check that the voltage stated on the ra-
ting plate (V) agrees with the supply vol -
tage in your home.
If the appliance is not fitted with a con -
nector plug, a two-pole switch, confor -
ming to standards with a minimum open
contact gap of 3 mm is to be installed by
an authorized tradesman in an easily ac -
cessible location.
Installation
!
Never install the appliance if the data
on the rating plate does not agree with
your supply voltage.
You will find the rating plate inside the
appliance, behind the grease filter.
If the extractor hood is fitted with a
standard connector plug, connect this
to an easily accessible standard socket.
EN
7.5 Mounting the carbon filter
1. Remove the metal grease filter.
2. The carbon filter is mounted in two
parts to the right and left of the motor.
Check whether the teeth correspond to
the direction of rotation of the respecti -
ve side.
3. Turn the activated carbon filter onto
the motor housing (usually clockwise).
4. Reinsert the metal filter.
Close