Kiva KLB2400E, Руководство пользователя

Страница: 44 / 52

1 7
FEATURES AND CONTROLS
Filling hopper
On/Off switch and
emergency stop
Wheel
Electric motor
Safety switch
Feed intake tube
Locking handle
Chipping chute
Plug-in socket
OPERATION
Discharge chute
WARNING: Before operating the machine, be sure to read all safety, controls
and operating instructions in this Owner's Manual and on decals located on
machine.Server personal injury or property damage could result if this
instruction is not followed.
1. Pre-operation checklist
Before using the electric chipper/shredder, with the power cable disconnected from the machine, please
perform the following procedures for the personal and property safety of the operator and jobsite and for
optimal performance.
1) Review section"safety"and section"features and Controls"which is in this owner's manual. Read all safety,
controls and operating instructions on decals located on machine.
2) Check and make sure that all nuts and bolts, especially the blade attachment-bolt, are tighten and all
guards and deflectors are in place and in good working condition. Tighten or replace as needed. If there are
any worn or damaged parts, DO NOT ATTEMPT TO OPERATE THE MACHINE. Make note of required parts,
and contact WEIBANG'S local dealer or WEIBANG's exclusive national distributor for replacement parts
and further assistance to service the unit PRIOR to any further use.
3) Check and make sure that all motor controls and the brake action functioning within acceptable tolerances.
4) Tighten any screws where necessary! Check the screws again after around 20 working hours!
5) Pay attention that the filling hopper is properly mounted!
6) Check and make sure that the cutting chamber is empty.
CAUTION: If any of the above checks fail, please take necessary steps to
maintain or repair the unit before operating it in any environment.
CAUTION: Always wear proper safety clothing and equipment for the job.
These can and should include eye and ear protection, gloves, dust mask
and any other items that are appropriate for the job and jobsite requirements.