4
5
Instructions for use
Charging the battery
Give the speaker a full charge before its first use.
1. Connect the supplied USB charging cable to the Micro USB charging port (8) and plug into power
2. The LED indicator (5) will be solid red whilst charging which will take up to 3 hours
3. Once fully charged the LED indicator (5) will turn off
Note:
Allow up to 4 hours for the first charge. You can charge and play your speaker at the same time,
but it needs extra charging time.
Battery protection mode
•
If you haven’t used the speaker for 90 days, the speaker will switch to battery protection mode automatically.
To cancel the battery protection mode, connect the Diggit to power, see point 1 of ‘Charging the battery’.
•
To keep the rechargeable battery in good condition, please discharge and recharge speaker every 3 months,
even if you use it or not.
Note:
For best sound quality when the battery is below 30%, it is best to charge the Diggit.
KS Diggit is IP55 water resistant
The speaker is rated IP55. The first 5 means that the speaker is protected against dust and contact.
Limited ingress of dust permitted. The second 5 means it protects from water jets from any direction,
but is not impervious to large amounts of water. Please do not directly immerse in water.
•
To ensure that the KS Diggit speaker is water resistant, please remove all cable connections and tightly
close the AUX/DC IN cap; exposing the KS Diggit speaker to liquids without doing so may result in
permanent damage to the speaker.
•
Do not
expose the KS Diggit to water while charging; this is very dangerous as doing so may result in
personal injury and permanent damage to the speaker or power source.
•
IP55 rating is defined as the speaker can stand water spray (water-carrying capacity 12.5 L/min) for up
to 3 minutes.
•
We do not recommend leaving the speaker outside at night time in wet conditions or when it’s raining.
Store in a dry place while not in use, this will prolong the speakers life.
