13
8.
Repeat steps 2 through 7 to install the other handle onto the
adjacent refrigerator door.
9.
With the drawer(s) closed, place the handle onto the shoulder
screws so that the setscrews are facing down toward the
floor.
10.
Firmly push the handle toward the drawer until the handle
base is flush against the drawer.
11.
Insert the short end of the hex key into the left-hand hole and
slightly rotate the hex key until it is engaged in the setscrew.
12.
Using a left to right motion tighten the setscrew a quarter-turn
at a time just until it begins to contact the shoulder screw. Do
not fully tighten.
13.
Repeat steps 11 and 12 to fasten the right-hand setscrew to
the shoulder screw.
14.
Once both setscrews have been partially tightened as
instructed in the previous steps, fully tighten both setscrews.
IMPORTANT:
When the screws feel tight, tighten them an
additional quarter-turn. The handle is not properly installed
without this extra tightening.
15.
For some models, repeat steps 9 through 14 to install a
handle on the second drawer.
16.
Save the hex key and all instructions.
Remove the Handles
1.
While holding the handle, insert the short end of the hex key
into a setscrew hole and slightly rotate the hex key until it is
engaged in the setscrew.
2.
Using a right to left motion loosen the setscrew a quarter-turn
at a time.
3.
Repeat steps 1 and 2 for the other setscrew. Slowly pull the
handle away from the door or drawer.
4.
If necessary, use a Phillips screwdriver to remove the shoulder
screws from the door.
Remove and Replace Handle Medallions (optional)
The handles for your model have red medallions on the ends.
Replacement medallions are available for purchase. See
“Accessories” to order.
1.
Using a 1/8" hex key, remove the medallion from the end of
the handle.
2.
Replace medallion.
3.
Using the fastener removed in Step 1, attach the medallion to
the handle.
Refrigerator Leveling, Door Closing and Alignment
The base grille covers the adjustable brake feet and roller
assemblies located at the bottom of the refrigerator below the
freezer drawer. Before making any adjustments, remove the base
grille and move the refrigerator to its final location.
Tools Needed:
1/4" hex driver
Tools Provided:
1/8" hex-key wrench
1.
Remove the base grille. Grasp the grille firmly and pull it
toward you. Open the freezer drawer to access the brake feet.
NOTE:
To allow the refrigerator to roll easier, raise the break
feet by turning them counterclockwise. The front rollers will be
touching the floor.
2.
Move the refrigerator to its final location.
3.
Lower the brake feet, by turning them clockwise, until the
rollers are off the floor and both brake feet are snug against
the floor. This keeps the refrigerator from rolling forward when
opening the refrigerator doors or freezer drawer.
IMPORTANT:
If you need to make further adjustments
involving the brake feet, you must turn both brake feet the
same amount to keep the refrigerator level.
A
B
A. Shoulder screw
B. Setscrews inside the handle
A
A. Handle medallion
INSTALLATION INSTRUCTIONS
Содержание KRFF507HBS
Страница 129: ...129 NOTES ...
