18
Oven Lights
The oven lights are standard 40-watt appliance bulbs. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the Off position.
To Replace:
1.
Unplug range or disconnect power.
2.
Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3.
Turn bulb counterclockwise to remove from socket.
4.
Replace bulb, and then bulb cover by turning clockwise.
5.
Plug in range or reconnect power.
Problem Solver
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid
a service call, refer to the warranty page in this manual and scan the code there with your mobile device, or visit
http://kitchenaid.custhelp.com
. In Canada, visit
http://www.kitchenaid.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
KitchenAid Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
In Canada:
KitchenAid Brand Home Appliances
Customer eXperience Centre
200-6750 Century Ave.
Mississauga, Ontario L5N 0B7
Please include a daytime phone number in your correspondence.
PROBLEM
POSSIBLE CAUSES AND/OR SOLUTIONS
Nothing will operate
Power supply cord is unplugged –
Plug into a grounded outlet.
Household fuse is blown, or a circuit breaker is tripped –
Replace the fuse or reset the circuit
breaker. If the problem persists, call an electrician.
The control panel displays an F9 or E0 Error code –
The electrical outlet in the home may be
miswired. Contact a qualified electrician to verify the electrical supply.
Cooktop will not operate
The control knob is not set correctly –
Push in knob before turning to a setting.
On ceramic glass models, the oven control lockout is set –
See “Control Lock” keypad feature
in the “Feature Guide” section.
Excessive Heat around
cookware on cooktop
Cookware is not the proper size –
use cookware about the same size as the surface cooking
area, element, or surface burner. Cookware should not extend more than
1
/
2
" (1.3 cm) outside
the cooking area.
Cooktop cooking results
not what expected
Control knob is set to incorrect heat level –
See “Cooktop Use” section.
Range is not level –
Level the range. See the Installation Instructions.
Cooktop element cycles
on and off on High setting
Element cycling due to a temperature limiter –
This is normal operation. The element may cycle
on and off to keep the cooktop from overheating.
Oven will not operate
Delay Start is set –
See “Cook Time” section.
Control lock is on –
Press and hold START for 5 seconds to unlock.
Control is in Demo Mode –
See the “Electronic Oven Controls” section. Demo Mode is used for
display models in showroom.
Electronic oven control set incorrectly –
See “Electronic Oven Controls” section.
