3
Cabinet Front View
Warming drawer can be installed as an indoor single or double
installation or installed under a single oven. Two warming drawers
under a single oven are shown.
NOTE: The warming drawer cannot be leveled after being
installed.
For outdoor installation, follow the cutout dimensions above.
Install the outdoor warming drawer in a permanent fixture.
Custom Wood Drawer Front
If you plan to install a custom wood panel to match your
cabinets, we recommend consulting a qualified cabinetmaker or
carpenter. The back of the wood panel must be sealed to avoid
moisture damage.
Electrical Requirements
IMPORTANT: The warming drawer must be electrically grounded
in accordance with local codes and ordinances, or in the absence
of local codes, with the National Electrical Code, ANSI/NFPA 70
or Canadian Electrical Code, CSA C22.1.
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine that
the ground path is adequate.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
■
A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is
required. A time-delay fuse or circuit breaker is also
recommended. It is recommended that a separate circuit
serving only this warming drawer be provided.
■
The model/serial rating plate is located above the left-hand
side receiving slide. The warming drawer must be removed to
view the model/serial rating plate. See the following
illustration.
WARMING
DRAWER SIZE
CUTOUT
WIDTH (A)
MIN. CABINET
WIDTH (B)
24" (61 cm)
22
¹⁄₂
" (57.1 cm)
24" (61 cm)
27" (68.6 cm)
25
¹⁄₂
" (64.8 cm)
27" (68.6 cm)
30" (76.2 cm)
28
¹⁄₂
" (72.4 cm)
30" (76.2 cm)
2
¹
/
₂
" (6.4 cm) min.
2
¹
/
₂
" (6.4 cm) min.
9
¹
/
₈
" (23.2 cm)
4" (10.2 cm)
B
Recommended 4
¹
/
₄
" (10.8 cm)
Minimum 1" (2.5 cm)
A
9
¹
/
₈
" (23.2 cm)
Toe
kick
Warming
drawer
cutouts
120 volt
grounded
outlet
(or located
in adjacent
cabinet)
A. Model/serial number plate
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
A
