KitchenAid 720-0733, Инструкция по установке и руководство по эксплуатации и уходу

Страница: 18 / 112

18
3.
Place the 20 lb LP gas fuel tank bottom collar into the
mounting hole in the tank tray.
4.
Tighten the locking screw against the bottom collar of the
20 lb LP gas fuel tank to secure.
5.
Slide the tank tray with the 20 lb LP gas fuel tank back into
the cabinet and lock the locking bracket.
To Connect the 20 lb LP Gas Fuel Tank:
1.
Check that the 20 lb LP gas fuel tank is in the “Off” position. If
not, turn the valve clockwise until it stops.
2.
Check that the 20 lb LP gas fuel tank valve has the proper
type-1 external male thread connections per ANSI Z21.81.
3.
Check that the burner control knobs are in the “Off” position.
4.
Remove any debris and inspect the valve connections, port,
and gas pressure regulator/hose assembly for damage.
NOTE:
Always keep the LP cylinder at 90° (upright)
orientation to provide vapor withdrawal.
5.
Using your hand, turn the gas pressure regulator/hose
assembly clockwise to connect to the 20 lb LP gas fuel tank
as shown.
Hand tighten only. Use of a wrench could damage the quick
coupling nut.
Make sure that the cylinder valve connection device properly
mates with the connection device attached to the inlet of the
pressure regulator.
6.
Open the tank valve fully by turning the valve
counterclockwise. Wait a few minutes for gas to move
through the gas line.
7.
Before lighting the grill, test all connections by brushing on an
approved noncorrosive leak-detection solution. Bubbles will
show a leak.
8.
If a leak is found, turn the tank valve off and do not use the
grill. Contact a qualified gas technician to make repairs.
9.
Go to “Check and Adjust the Burners” section.
A. Locking screw
B. Bottom collar
C. Mounting hole
A
C
B
A. Gas pressure regulator/hose assembly
B. 20 lb LP gas fuel tank
A
B