KitchenAid 5KSS1121, Руководство пользователя

Страница: 16 / 132

16
TROUBLESHOOTING TROUBLESHOOTING
IMPORTANT: Before you call for service, check the list of problems and solutions below:
1. Sparkling Beverage Maker does
not work:
• You might be out of CO
2
; replace your
CO
2
Cylinder by exchanging it for a
full SodaStream 60 L CO
2
Cylinder.
• Check that the carbonating bottle has
been filled up with water to the fill line.
• Ensure that the Sparkling Beverage Maker
is always in the upright position.
• CO
2
Cylinder may be loose. Do not use
tools. Detach the bottle, open the rear
cover, and retighten the CO
2
Cylinder.
Apply firm pressure but do not over
tighten. If the CO
2
Cylinder is already
firmly in place, it may be empty. Replace
with a full 60 L SodaStream CO
2
Cylinder.
WARNING: Use caution when removing
cylinder as it may be very cold.
2. Cannot pull bottle loader tab:
• Make sure Carbonation lever is in its fully
upward position.
• Pull bottle loader tab firmly towards you.
3. Cannot install the carbonating bottle:
• Make sure the carbonating lever is in its
fully upward position.
• Pull the bottle loader tab toward you
until it clicks.
• Insert bottle into Snap-Lock
• Push bottle up and back until it locks.
4. You hear CO
2
escaping from
the bottle during carbonation:
• Bottle may not be properly attached.
Allow the Sparkling Beverage Maker
to finish the carbonation process and
then you can detach the bottle and
reconnect it following the instructions
in the “Making sparkling water” section.
• It is normal to hear a small amount
of CO
2
discharge at the end of the
carbonating process.
5. You want to re-carbonate a drink
that was already carbonated:
WARNING: Never carbonate again
after you have added the flavour. You
may recarbonate only unflavoured
sparkling water.
6. If your Sparkling Beverage Maker
continues to release CO
2
after
carbonation is finished:
WARNING: Do not remove the cylinder
or the bottle. Leave the Sparkling Beverage
Maker in an upright position. Do not touch
it until you no longer hear CO
2
escaping.
When the Sparkling Beverage Maker is
no longer releasing CO
2
, remove the
carbonating bottle, and call for service.
See “Warranty and service” section for
more information.
W10624164A_FINAL.indd 16 7/2/14 9:13 AM