KisanKraft
TM
KNAPSACK BATTERY SPRAYER
KK-KBS-165/167/169/183/185/187/189
KNAPSACK MANUAL CUM BATTERY SPRAYER
KK-KMB-4184
: www.kisankraft.com
: +91.80. 22178200
Page 14 of 24
When charging, you only insert the output of the charger to the jack and then connect the input
with 220V alternating current. The signal light on the charger is red during normal charging. It will
change to green when it is fully charged.
The conditions for using the charger:
Standard Voltage
AC100V
～
240V
Input Frequency
50/60Hz
Using Temperature
＋
10
℃
～＋
30
℃
Storing Temperature
－
10
℃
～＋
40
℃
Using Place
Only inside
The time of charging for the new machine or a machine stored for a long time must
be 24 hours.
Don’t let the switch in the place of “
一
”
while charging.
Please pull out the wire of the charger from the jack after the charging is completed.
An Improper battery wire connection will burn the battery and charger. The red wire
should be connected with the red end of the battery.
Don’t charge in a wet room or with wet hands,
as it may cause an electric shock.
Please use the special charger for this machine in order to avoid fire. In addition, it is
prohibited to charge any other electrical machines with the special charger of this
machine or as a power source.
Please pull out the wire of the battery from the socket once the charging is completed.
Don’t let this machine
exposed to the sun, high temperature conditions and the things
radiating heat, which may lead to ageing of the battery, battery leakages, radiate heat,
split and even fires.
If you find the charger abnormal, pull out from the plug immediately in order to avoid
electric shock, radiating heat and causing fires.
Don’t adopt generator as the electrica
l source of charging, which may destroy the
charger. Don’t
pull the wire off the charger forcibly.
Please clean the electrical pick off of the battery with dry cloth. Bad connection will cut
the power supply or may result in charge failure.
Be sure of the safety, please store this machine in place out of reach of children and
infant in order to avoid an electric shock.
If the battery of this machine needs to be replaced, it must be confirmed by the company. The
disabled battery couldn’t be thrown away anywhere. Please send it into the proper recycle
center which can deal with it.
3. Connection of the spraying parts:
a) Fix the spraying pole in the place as shown in the figures.
b) Insert the spraying pole into the switch and fasten the screw cap.
Caution
: Don’t fasten the
nut with the pliers, or it may harm the nut.
c) Hold the knob assembly with one hand and adjust the direction of the nozzle by holding
the spraying head with the other hand.