KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-250D,256D,215D
: +91.80.
6835 7800
Page 21 of 50
! NOTE:
Don’t suddenly release starter grip let it bounce back, it may broke engine. Need
slowly put the grip back.
1.6 After preheating the engine, gradually move choke to OPEN position.
1.7 Adjust rotary speed of engine through the throttle switch (or throttle handle)
Stopping the Engine
1.
Set the speed governor lever at low speed position
and run the engine without load for 2 to 3 minutes.
2.
Set the speed governor lever at "stop" position. Don't
use decompression lever.
3.
Set the fuel cock at "S". (Stop position).
4.
Pull the recoil handle slowly until pressure is felt by
your hand (that means at the point of compression
stroke, where the intake and exhaust valves are
closed. This could prevent cylinder from getting
rusted).
5.
If the engine possesses electric starter, tum the start
key switch to "OFF" position.
Speed governor lever
Fuel tank
Fuel switch
Maintenance
Do periodic maintenance to keep Inter-cultivator in good working condition. Please follow
the schedule below.
1. Maintenance of Engine
It is important for the economical and safety's sake to keep proper maintenance. At the
same time to reduce pollution.
WARNING:
•
Improper maintenance and not solving the problem before engine operation may
cause personal injury or death.
•
Please check and maintain the engine according to the methods recommend by
user’s manual.
•
Stop the engine before maintenance in order to avoid the potential dangers as below:
o
The engine exhausts poisonous carbon monoxide. Keep the good ventilation
when the engine works.
o
The scald of heating parts.
o
Let the exhaust parts cool down before you touch.
o
The injury of rotary parts.
o
If you have to run the engine, please keep away from the rotary parts
!
NOTICE
: Use original spare parts or another qualified substitute. Using unauthorized
spare parts may damage the engine.
