KISANKRAFT KK-BC2-JP30, Руководство по эксплуатации

Страница: 19 / 68

BRUSH CUTTER
KK-BC2-JP30/JP45 , KK-TC2-JP45

: www.kisankraft.com

: info@kisankraft.com

: +91.80. 22178200
Page 19 of 68
 When fuel is remaining and the engine is warm, move the choke lever to the fully
open position ( mark side).
CAUTION: To avoid serious injury.

Do not pull the recoil starter rope out completely. This can damage
the unit.
 Do not let the recoil starter grip snap back. This can cause bodily
injury or damage the unit.
 Place the unit on the ground.
 Check that the cutting tool is not touching the ground or any other obstacles.

Hold the unit with your left hand and press it down firmly.
 Pull the recoil starter grip (6) slowly with your right hand until you feel it engage
and then give it brisk strong pull.

After starting, watch the engine condition and move the choke lever slowly to the
full open position ( mark side),
NOTE:
When the explosion sound is heard, but the engine does not start, move the choke lever
the full open position and again pull the starter knob rapidly.
CAUTION: To avoid serious injury.

Do not increase the engine speed immediately after starting as the
lubrication oil is not yet evenly distributed to every part.
 When the throttle is in fully open position, the engine speed
becomes considerably high, and that not negatively affects the
engine life but it also can cause engine failure. Do not race the
engine (high revving with the engine at idle), and also avoid
unnecessary high-speed operation.

Release the throttle trigger. Warm up the engine at the idling speed for a few
minutes.
NOTE:
As the engine becomes warm, smooth acceleration is obtained.