KisanKraft
TM
POST HOLE DIGGER
EQ9800
: www.kisankraft.com
: +91.80. 22178200
Page 10of 20
OPERATION:
When preheating the gasoline
engine, gradually move the handle of
the choke valve to the “OPEN”
position.
Then, adjust the handle of the throttle
valve upward and set it at the position
of the required running speed of the
engine.
CAUTION
To give full play to the product performance, It is suggested to run the gasoline engine for
about 15 minutes in the low-speed state if the engine is used for the first time. Heat the
engine for 3~5 minutes and then get it into the working state every time when it is to be
used.
Shutdown
Directly press down the stop switch or pull off the spark plug cap in case of shutdown in an
emergency. Generally, conduct the operation based on the following steps:
1. Release the load firstly; then press down the handle of the throttle valve to reduce the
rotating speed of the gasoline engine.
2. Press down the stop switch after 2~3 minutes of no-load running.
CAUTION
Under normal circumstances, it is strictly prohibited to directly shut the engine down in the
case of no load off.
WARNING:
For the sake of your health, please be far away from the muffler and do not directly face the
exhaust port during operation of the gasoline engine. Pay attention to the unusual change
of the gasoline during its operation. Immediately shut down the engine in case of abnormal
sound, severe vibration, unstable rotating speed, blasting and other adverse phenomena of
the gasoline engine.
Make sure the unit is in a stable position before pulling the starter handle.
When the unit starts to fire or run, release the throttle control momentarily with
your right hand and return your left hand to the handlebar position to maintain
control and stability of the unit with both hands.
