Kisae Abso Charger 12V 100A, Руководство пользователя, Страница: 8 / 26

Page 8
Typical wiring block diagram of the Battery Charger with 3 battery banks
•
AC Source:
The charger accepts full universal input voltage (90-265Vac, 47-63Hz).
•
Branch Breaker:
For use on 120V AC Input source, use a 15A branch breaker to connect between the AC Source
and the charger AC Input hardwire cable (Hot
–black wire, Neutral–white wire, Ground–green
wire).
For use on 230V AC Input source, a minimum of 8A branch breaker is required from the AC
Input Source.
•
Battery Bank 1, 2 & 3:
There are a total of three channels (CH1, CH2, CH3) available for charging three battery
banks (Battery Bank 1, Battery Bank 2, Battery Bank 3).
•
Chassis Ground:
The unit chassis has to be grounded properly to the common ground point on the system.
•
Digital Remote (optional):
The Display Remote ( Part Number : ACRM1202 ) sold separately is used to provide unit
information from the charger. It is used as a secondary display to provide charger information.
This can also be used as a main display or controller to connect two AC Chargers of the
same model running in parallel.
•
Battery Temperature Sensor
– BTS (optional):
The Battery Temperature Sensor BTS ( Part Number: BTS-10K ) sold separately is designed
to use on Battery Bank 1 (CH1) for better battery charging performance. The sensor is also
used to terminate the battery charging process when it senses the battery temperature is
either too high or too low and is not suitable for charging.