KIRLOSKAR 8 UP 200/38, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 66

IOM/UP_METRIC Issue Date: 31/12/2007
Page 10 of 66
Last Revision: 12/06/2012
2.6.3:
Storage.
2.6.3.1: Temporary storage for up to six weeks
.
If the pump unit is not be used immediately it should be stored carefully in a
horizontal position, in a sheltered, dry location. Additional rust preventive should be
applied to all unpainted carbon steel or cast iron parts, and should not be removed
until final installation.
2.6.3.2: Long Term Storage.
If the pump is not to be installed and operated soon after arrival, store it in a
clean, dry place, having slow, moderate changes in ambient temperature. Step
should be taken to protect the pump from moisture, dust, dirt, and foreign bodies. It
is recommended that the following procedure is taken:-
a) Ensure that the bearings are packed with the recommended grease, to prevent
moisture from entering around the shaft.
b) Remove the glands, packings and lantern rings from the stuffing box if the pump
is equipped in this manner. If the pump is equipped with mechanical seal, dismantle
and coat the seal with light oil.
c) Ensure that suction and discharge branches of the pump and all other openings
are covered with cardboard, wood or masking tape to prevent foreign objects
entering the pump.
d) If the pump is to be stored where there is no protective covering, it is advisable to
cover the unit with a tarpaulin or other suitable covering.
e) The shaft should be manually rotated periodically to prevent pitting of the bearing
surfaces by moisture.
Shearing Hazard.
Do NOT place fingers or hands etc. into the suction or discharge pipe outlets and do
NOT touch the impeller, if rotated this may cause severe injury. To prevent ingress
of any objects, retain the protection covers or packaging in place until removal is