6
7
2.3 Rear Panel
Antenna Interface
Power Interface
External Speaker Interface
3. Basic Operation
1.Startup:
Press the red POWER button for a long time (at least 1.5 seconds)
to switch the radio on/off
2.Volume:
Press the MONITOR or Squelch Off button to listen to the
background noise first, and then adjust the volume by turning the
volume control knob.
3.Channel
The radio can provide 8 general channels. Press the CHANNEL
UP or CHANNEL DOWN button to select the channel.(Refre to P7
4 Programmable Button Function)
4.Transmission:
To send a call, press the PTT button and speak to the microphone
Display
Description
Displays "
P
" when the radio enters the PC
Programming Mode.
Displays "
t
" when the radio enters the PC
Adjustment Mode.
Displays "
C
" when the radio enters the Wired
Clone Mode
in th e normal voice. Please keep the microphone about 3 or 4 cm
far from your mouth. After speaking, please loosen the PTT button.
5. Receive:
The radio will return to the receiving state after you loosen the
PTT button. The distributor may have set the CTCSS/DCS
signaling in your radio. On the channels with CTCS S/DCS are
set, you can only hear the call from other radio with the same
CTCSS/DCS.
4. Programmable Button Function
P1 P2 P3
/ can be programmed as one of the following
functions.
0. None
1.Channel Up
2.Channel Down
3.Talk-around
4.Call Button 1
5.Call Button 2
6.Lone worker
7.Emergency
A
larm
8.Emergency
A
larm Off
9.Scan
10.Nuisance Delete
11.Hi-Low Power
Switch
No function
Select the next channel
Select the previous channel
Switch the radio mode between talk-around and repeater.
Sends the DTMF/2Tone code assigned to call 1 button.
Sends the DTMF/2Tone code assigned to call 2 button.
Enables Lone worker function
Press the button programmed as
Emergency Alarm
to set alarm tone according to the programming software
or send your own ID or background voice to your partner
or the system.
Press this button to quit the Emergency Alarm mode.
Start/end the scanning function of system.
Press this button Nuisance Delete when the radio enables
the scan function and stays at the noise channel.
Press to switch between high and low power of the sen ding
power of the radio, when the
LOW is on the display,
