Code Squelch is either enabled or disabled by your dealer.
This function opens the squelch only when the transceiver
Receives a predetermined DTMF code that has 3 to 10 digits.
Usually, each transceiver would be programmed with a unique
code.Transceiver not transmitting the correct code will not be
heard. Consequently, this function allows you to readily
communicate With a single specific transceiver without
listening to other transceivers that share the same channel.
Your dealer also may activate Group Call for your transceiver.
This is useful when you want to pass information to a number
of units in a Fleet. Ask your dealer for details.
RECEIVING
When the same code is received that was programmed in the
transceiver By your dealer, the squelch opens, and the caller is
heard without any Further action.
Receiving the correct code causes CH- and channel
number to appear on the Display and the LED to flash orange.
Press [MONI] mutes the speaker after Code Squelch has
opened The squelch.
If so programmed by your dealer, after Code Squelch opens
the squelch, the squelch automatically closes when a
programmed time period Passes.
If your dealer has programmed Transpond, an
acknowledgement signal is returned from your transceiver to
Code Squelch cannot be used on a channel that your
dealer has Programmed with Selective Call.
Note:
TRANSMITTING
1. Refer to the MANUAL DIAL or Transmitting stored DTMF
code to Make a call by DTMF keypad.
Make sure to enter the correct DTMF Code.
CH- and channel Number displayed on LCD, and LED
indicatorturns red.
2. Use the transceiver with the usual calling method, press to
talk, and release to receive.
The squelch on the transceiver being called will remain open
for as long as you are transmitting plus a time period after you
stop transmitting. This time period is programmed by your
dealer.
Release [PTT] causes the squelch to open and the LED to
flash Orange, when the transceiver receives a signal, the LED
lights Green. After the transceiver receives no further signals,
the LEDFlashes orange again. After a time period programmed
by your dealer passes during which no signal is received, the
squelch closes And LED goes OFF.
Pressing [MONI] also causes the squelch to Close and the
LED to go OFF.
the station that called. However, Transpond does not function
when you are called with a Group code.
If your dealer has programmed Tone Alert, both Tone Alert
and Code Squelch can function together.
CODE SQUELCH
2
17
2
18
