Upright & Portable Cleaner
THE HARD FLOOR PAD (optional)
By attaching the optional Hard Floor Pad to your Sentria
™
,
system you may dust bare floors. While the unit is turned
OFF, raise the Power Nozzle (25) as far as it will go by press-
ing the Toe-Touch Control Bottom Pedal (9). Attach the
Hard Floor Pad onto the nozzle opening using the spring
clips on the plate. Then lower the Power Nozzle by pressing
the Toe-Touch Control Upper Pedal (8) one notch at a time
until the bristles touch the floor.
NOTE: The Hard Floor Pad should only be used when the
unit is in the Straight Suction Cleaner mode. •
PORTABLE CLEANER SET-UP
Besides being a remarkable Upright Cleaner, the Sentria sys-
tem can easily be converted into a portable cleaner for mat-
tresses and carpeted stairs.
1
To convert your Sentria system to a Portable Cleaner,
make sure the unit is turned OFF, unplugged, and the
Tech Drive
®
pedal is in neutral.
Then release the Outer Permanent Bag Top from the Bag
Support by pressing the Bag Release Button (16) and sliding
the bag top off. >
2
Remove the cord from the handle. With the Upright
Handle (17) in the vertical position, push the Handle
Release Button (14), located at the base of the handle,
and pull the handle straight up and out of the slot.
(Bag not shown for clarity.) >
3
Insert the Portable Handle (15) into the slot where the
Upright Handle was connected. Push the Portable
Handle into the slot until it snaps into place. >
/!\ CAUTION:
Before installing the Hard Floor Pad, turn unit OFF, unplug the power cord
from the wall outlet and be sure the motor and nozzle brush have stopped.
16
