KIRAMI CH 23, Инструкция по эксплуатации

Страница: 29 / 72

© Kirami Oy, Finland
CF 23 – Cartridge filter system
P
AGE
5/11
Hose connections
The device is connected with two hoses to the pool. Suction that is the hose leaving
the pool is connected to the lower part of the device (Image 1 - IN).
The return hose where the water flows back to the pool is
connected to the top part (Image 1 - OUT).
Notice that the OUT connector can be turned to wanted direction.
1. That hose connector elbow is connected by using thread
tape about 15 turns on the thread. Use a 38mm inside
diameter hose for connections with suitable hose clamps.
Keep in mind that the threaded connector can leak if it’s
screwed backwards. You may have to start the procedure
from the beginning. Plan the screwing so that the return
connector settles in the desired direction. Normally, it is
not necessary to screw the hose connector completely to
the bottom.
2. Install suction side parts in the same order as in the image
below (image 2)
3. Wrap the thread tape clockwise around the external
threads of the pressure gauge and screw it to the top of
the filter system. Also check that the pressure gauge and
breather valve are properly in place and use thread tape if necessary.
4. Connect the hoses to the IN and OUT hose connections. The hoses must have an inside diameter of
38 millimeters (minimum) and must be secured with suitable hose clamps.
IN
OUT
Image 1
Image 2
29/72
06.02.2021