© 2005-2012 KIRAMEK, INC.
18
FEATURE PROGRAMMING
To program features you will need to open the 1440
control module and use the Program Switch inside. The
following 3-step procedure enables programming of the
features shown in
Table-2
at bottom.
1.
Disarm the system.
(Or “Arm-then-Disarm” if repeat-
ing this procedure.)
2. Within 5 sec.
of disarming, press and release the Program Switch.
3.
7KH/('LQVLGHWKH&RQWURO0RGXOHZLOOVORZO\ÁDVK5('
Count the
ÁDVKHV
.
:KHQ WKH QXPEHU RI ÁDVKHV PDWFKHV WKH IHDWXUH ´1Rµ \RX
wish to change in
Table-2
,
press-and-hold Program Switch.
Release
when the LED lights GREEN. The Green LED shows the feature set-
WLQJ KDV EHHQ FKDQJHGWRJJOHG 7KH QXPEHU RI *UHHQ ÁDVKHV VKRXOG
match the feature number you have chosen.
To go back to the previous
setting, Arm the system and repeat this procedure at Step-1.
NOTES:
(1) There is no visual indication to let you know which setting
\RXKDYHFKRVHQ³VLPSO\WHVWWKHV\VWHPWRFRQÀUP\RXUVHOHFWLRQ
,I\RXQHYHUSUHVVWKH3URJUDP6ZLWFKLQ6WHSWKH/('ZLOOÁDVK
15 times and then exit the routine. In this case, go back to Step-1 to re-
enter feature programming. (3) You must repeat this procedure for each
feature you wish to program, and each time you wish to toggle settings.
Program Switch
TABLE-2
Feature Selection Menu
No. Feature Description
Toggle Settings
6
Confirmation Chirps
ON
OFF
7
Vehicle Lights ON During Remote Start
ON
OFF
8
IG Protect Mode / Remote Start C. Mode
IG Protect
RSCM
9
Siren Output
Continuous
Pulsed
10
IIP Trigger Selection
All
Door
13
Error Chirp
ON
OFF
14
Exit Delay Time Selection
5 sec.
40 sec.
FACTORY DEFAULT SETTINGS SHOWN IN BOLD TEXT ABOVE
See Owner’s Guide pages 9-10 for explanations of features.
