11
© 2005-2014 KIRAMEK, INC.
11
FORCE RESET
In the event the battery in your factory remote dies or the factory remote
itself is lost, the 1440 can be manually reset (i.e., “disarmed”) using a se-
cure procedure.
Program Switch
Purpose
The VISION factory default Reset Code is set to
“6.”
It is strongly recommended that you change this
code to something unique. To change the Reset Code
you will need to gain access to the Control Module and
open the case to use the Program Switch. If you can-
not do this yourself, please ask your VISION dealer/in-
staller to assist you.
The following procedure will allow you to change the Reset Code:
1.
Arm and then immediately Disarm with the factory remote.
2.
Within 5 seconds of Disarming, press and release the Program Switch.
(The LED inside the Control Module will start to turn on and off very
VORZO\<RXPXVWFRXQWWKHQXPEHURI/('ÁDVKHV
3.
Turn on the Ignition
before
WKH/('ÁDVKHVWLPHV
(Continue counting
/('ÁDVKHVZKLOH\RXWXUQRQWKH,JQLWLRQ
4.
When the LED lights up for the
5th
time, press and hold the Program
Switch and then release the button when the LED turns Green. The
/(' ZLOO QRZ ÁDVK *UHHQ PRUH WLPHV DQG WKHQ VWDUW WR ÁDVK 5HG
Consider the Reset Code number you want to program before the LED
ÁDVKHV5HGDJDLQ
5.
:KHQWKH/('VWDUWVWRÁDVK5HGDJDLQFRXQWWKHQXPEHURIÁDVKHV
:KHQWKHQXPEHURIÁDVKHVPDWFKHVWKHFRGH\RXZLVKWRSURJUDPWXUQ
off the Ignition.
The LED will turn Green again and the siren will chirp
WLPHVWRFRQÀUP\RXU5HVHW&RGHKDVEHHQSURJUDPPHG
NOTE:
Make time now to record your new Reset Code and store it
in a safe place.
Programming Your Unique Reset Code
