7
© 2005-2014 KIRAMEK, INC.
SYSTEM FEATURES
GWA (Ground When Armed)
The 1440 feeds a (–) Ground output while the system is armed. Optional
components can be added to this control line, such as a Starter Kill Im-
mobilizer Relay or vehicle lighting devices. When the system is disarmed,
power to this output is removed and all attached devices shutdown.
See the
Installation Guide
IRUGHWDLOVRQHOHFWULFDOVSHFLÀFDWLRQV
LIGHT FLASH
9HKLFOH OLJKW ÁDVK FDQ EH DGGHG WR PRVW YHKLFOHV E\ D VLPSOH FRQ
-
nection to the vehicle’s factory light control relay
(see “Installation
Guide” page 9)
. For some vehicles, you may need to change the po-
larity with the purchase of an optional
VISION
896H-1C
relay
.
:KHQLQVWDOOHGOLJKWVZLOOÁDVKFRQWLQXRXVO\ZKLOHWKHVLUHQLVJRLQJRII
GXULQJWKHIXOOVHFRQGVDQGÁDVKHVWLPHVGXULQJ´:DUQLQJµWULJJHUV
(e.g., shock sensor 1st-stage trigger).
2-STAGE SENSOR TRIGGER
1st Stage (“Warning Chirps”).
When the included shock sensor
detects a light impact to the vehicle body, the siren will chirp 5
times. Note that any optional sensors attached to the shock sen-
sor’s 1st Stage input can also trigger 5 warning chirps.
No chirps
will be produced while in Sensor Bypass Mode.
2nd Stage (“Full Siren”).
When the included shock sensor de-
tects hard impact on the vehicle body, the siren will go off for 30
seconds (or until disarmed with the factory remote). Note that
any optional sensors attached to the shock sensor’s 2nd Stage
input can also trigger the full siren blast sequence.
The siren will not be
triggered while in Sensor Bypass Mode.
PAGER OUTPUT
This wire goes to (–) Ground for 15 seconds whenever the full siren blast is
triggered
(not during Warning Chirps)
. It supplies up to 1-Amp to power
optional paging systems (not currently available from KIRAMEK) or other
devices you wish to turn on only when the siren is going off.
