Kipor IG3000, Руководство по эксплуатации

Страница: 11 / 18

8.3A
The DC receptacle may be used for charging 12 volt automotive-type batteries only.
Output voltage is 15-30V when current receptacle on no load. DC output will vary
according to the position of the Smart throttle switch. When the Smart throttle switch
is truned to the ON position and the AC output is not used, the DC current will be
about one-third of the rated current.
DC current:
To prevent the possibility of creating spark near the battery, connect charg-
ing cable first to the generator, then to the battery. Disconnect cable first at
the battery.
Before connecti g charging cable to a battery that is installed in a vehicle,
disconnect the vehicles grounded battery cable. Reconnect the vehicle's
grounded battery cable after the charging cables are removed. This proced
dure will prevent the possibility of a short circuit and sparks if you make acc
idental contact between a battery terminal and the vehicle's frame or body.
n
Do not attempt to start an automobile engine with the generator still conn-
ected to batter. The generator may be damaged.
Connect the positive battery terminal to the positive charging cord. Do not
reverse the charging cables, or serious damage to the generator and/or
battery may occur.
The battery gives off explosive gases; keep sparks, flames and cigarettes
away. Provide adequate ventilation when charging.
The battery contains sulfuric acid (electrolyte). Contact with skin or eyes
may cause severe burns. Wear protective clothing and a face shield.
A. If electrolyte gets on your skin, flush with water.
B.If electrolyte gets in your eyes, flush with water for at least 15 minutes
and call a physician.
Electrolyte is poisonous.
A. If swallowed, drink large quantities of water or milk and follow with milk of
magnecia or vegetable oil and call a physician.
Keep out of reach of children.
5.1 AC applications
1.Start the engine and make sure the output indicator light (green) comes on.
2.Confirm that the appliance to be used is switched off, and plug in the appliance.
5.2 Output and Overload Indicators
The out indicator light (green) will remain ON during normal operating conditions.
If the generator is overloaded, or if there is a short in the connected appliance, the
output indicator light (green) will go OFF, the overload indicator light (red) will go
ON and current to the connected appliance will be shut off.
Stop the engine if the overload indicator light (red) comes ON and investigate the
overload source.
Check engine oil if the oil alarming indicator (Red) Comes ON.
SMART throttle switch
Model
IG3000
1.Connect the charging cable to the DC receptacle of the generator and then to the
battery terminals.
OFF
ON
(do not use the AC output)
approximately 2.8A
CAUTION
Substantial overloading that continuously lights the overload indicator light
(red)may damage the generator.Marginal overloading that temporarily lights
the overload indicator light(red)may shorten the service life of the generator.
Be sure that all appliances are in good working order before connecting
them to the generator. If an appliance begins to operate abnormally, be-
comes sluggish, or stops suddenly, turn off the generator engine switch
immediately. Then disconnect the appliance and examine it for signs of
malfunction.
Before connecting an appliance to the generator, check that it is in good
order, and that its electrical rating does not exceed that of the generator.
Then connect the power cord of the appliance, and start the engine.
When an electric motor is started, both the overload indicator light (red)
and the output indicator light (green) lights may go on simultaneously. This
is normal if the overload indicator light(red) goes off after about four (4)
seconds. If the overload indicator light(red) stays on, consult your dealer.
NOTE
NOTE
-12-
5.3 DC application
WARNING
CAUTION
WARNING
-13-