1-92
3. 2. 7 Mis-feed around the Bottom Corner Region
(Code: J-0112, J-0212 & J-0412)
When the roll media is mis-fed around the Bottom Corner region, any of J-0112, J-0212 and
J-0412 is indicated. (Refer to the following section picture for the location of mis-fed media.)
Bottom Corner region
Remove the mis-fed media as instructed in below.
1. Open the Transportation Units 4. The mis-fed media will be found inside.
2. Check if the mis-fed is cut or not by pulling it.
Whether the media is cut or not decides what to do
next.
•
If the mis-fed media is cut and can be removed
from the machine easily, proceed to the
following procedure 3.
•
If it has not been cut yet so can not be
removed from the machine, jump to the
procedure 4. (Procedure 3 is not needed.)
NOTE
Make sure to open the Transportation Units before removing the mis-fed media. Otherwise the
inside of machine will become dirty with the toner.
Transportation
Unit 4
