Kioti KL2042, Руководство оператора, Страница: 32 / 40

29
NOTE
If you have to replace one or both rear wheels or tyres,
make sure that any differences in their external diameter does not exceed
8-10 mm. Change in wheel/tyre size may cause an uneven cut & may be
necessary to adjust the alignment of the cutting deck.
IMPORTANT
Before remounting the wheel, apply
grease to the axle. Put the snap ring (1)
& supporting washer (2) back in place.
6.3.3 Replacing & repairing the tyres
The tyres are «Tubeless» and so all punc-
tures must be repaired by a tyre repairer
following the procedures required for this
kind of tyre. If you have to replace a tyre, make sure that any differences in their
external diameter does not exceed 8-10mm
1 2
6.3.4 Replacing the bulbs
(if present)
The bulbs (18W) have a bayonet
fitting and are installed in the
bulb holder which can be taken
out by turning it anti-clockwise
with pliers.
6.3.5 Replacing a fuse
The machine is fitted with
fuses (1) with different
capacities and functions.
Specifically:
– 10 A fuse = protects the
main and power circuits
of the electronic board.
When it blows, the
machine stops.
– 25 A fuse = protects the battery charger circuit. When it blows, the battery
gradually lose charge and the machine will have problems starting.
The fuse capacity is indicated on the fuse.
IMPORTANT
A blown fuse must always be replaced by one of the
same type and ampere rating, and never with one of another rating.
If problems persist, contact Your Dealer.
1
1
6. MAINTENANCE (cont.)