Kioti DK55, Руководство пользователя

Страница: 104 / 135

10-20 DK55
069OA33A 069OA32A
IMPORTANT
IMPORTANT
Do not operate the tractor imme-
diately after changing the trans-
mission fluid.
Run the engine at medium speed
for a few minutes to prevent
damage to the transmission.
1. To drain the used oil, remove the drain
plug at the bottom of the transmission
case and drain the oil completely into
the oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new KIOTI TF65 fluid up to
the upper line of the gauge.
(See “LUBRICANTS” in Maintenance
Section)
4. After running the engine for a few
minutes, stop it and check the oil level
again; add oil to prescribed level.
Oil Capacity
38
(10.0 U.S.gals.)
CAUTION
To avoid personal injury:
Allow engine to cool down
sufficiently, oil can be not and can
burn.
FULE FILTER ELEMENT
REPLACEMENT
(1) Fuel Filter Ass’y (2) Fuel Filter
1. Clean up the surface of the fuel filter.
2. Drain water and oil by turning off & loos-
ening the sensor in the bottom of the
fuel filter.
3. Replace new filter after the old fuel fil-
ter removed.
4. For new filter replacement, bring the
p a c k i n g i n t o c o n t a c t w i t h t h e s e a l
surface, then turn it around 2/3 by hand
to lock.
5. Open the air plug and operate the prim-
i n g p u m p u n t i l t h e a i r i s b l e e d e d
completely.
6. Lock the air plug after bleeding the air.
Be careful not to leave dusts and
motes on the element when the
element is replaced.
(1) Gauge (2) Oil Filling Plug
(A) Oil Level is Acceptable Within This Range