17
Troubleshooting
Display Protection Condition
Description
Normal Condition Cause/Solution
OCP
Over Current Protection
Shut down current 2.52A
in excess of 20%
2.1A @ 100% dim
Repair Service
Center
OVP
Over Voltage Protection
Shut down voltage @
excess 30V
Below 28V
Wrong Battery
or 24V Battery
w/ too high
Open Voltage
UVP
Under Voltage Protection Shut down voltage @
below 17V
Excess 18V
Dead Battery
OTP
Over Temperature
Protection
Shut down temp @
120°C (LDM board side)
Below 120°C @
LED array
Cool Down
OPP
Open Protection
Open circuit
No open
Repair Service
Center
SCP
Short Circuit Protection
Short circuit
No short
Repair Service
Center
Troubleshooting continued
Can’t set the DMX address.
You must Press and Hold the DMX Address button for 3 seconds in order to
select an address. The display will flash while in edit mode. Select a valid
address from 1-512. (Note: 0 or 513 and higher are invalid addresses.)
Can’t operate the fixture manually with the DMX cable plugged in.
Two Options:
Set DMX address to “0” or disconnect cable and turn power off and on.
Can’t link to wireless transmitter.
Fixture must be receiving power. Power/Wireless button must be in the “On”
position and blue light must be displayed.