4.2 Limit switch adjusting
4.2.1 Loosen the left and right lock bolts by a cross head screwdriver, at the
same make sure the gear pins don’t touch the micro switch.
4.2.2 Turn on the power, and make the motor run, confirm the status of the
rolling pipe, is it rolling up or rolling down.
4.2.3 When the motor is rolling up the plastics, rotate any of the knobs slowly,
and make the gear pin touch the micro switch( with click sound) , if the
motor stops running, it means this adjust ring controls the direction of
the rolling.If the motor doesn’t stop running,the other adjust ring is used
to control the direction of the rolling.
4
、
Limit range adjusting
4.1 Limit switch illustration
CAUTION: After the limit adjust is finished, please fasten the bolts. Or the
limit will not be accurate and there would be dange of power shock.
Left gear pin
Left lock bolt
Left knob
Right gear pin
Right lock bolt
Right knob
Micro switch
3
、
Installation instructions
3.1 First please fasten the pipe and this product with the bolts.Then fix
the film into the pipe by the film hoop, please keep the pipe and the
output shaft of this product on the same line;then start the motor
and operate the opening and closing the films.
3.2 Two types of pipe could be used for this motor, the diameter is Φ27,
Φ33.5. When the Φ33.5 pipe is used, the “suit ”is needed,the Φ33.5
pipe doesn’t need it.
3.3 The pipe for top opening is Φ33.5.
GMD300-S
300N m
20A
300W
1＂ tube：80m(L)×4m（H）
1＂（OD33）
1＂（OD33）
DC24V±3V
3.5r/min
45rounds/80rounds
IP55
·
Model
Maximum torque
Maximum currency
Rated power
Rolling capacity
（Recommended）
Rolling pipe specs
（top/side）
Guiding pipe specs
（top）
Input voltage
fullloaded speed
Maximum range
（output shaft）
Grade
4
7
Before limit adjust ,please lossen “left or right fasten bolts”
After limit adjust,please fasteb “left or right fasten bolts”
